Let me try to make this more clear.
There are 4 delay taps that you can use.
Each tap can be set to a different ms time.
So YES you can have a...
I can't speak for all of the other presets,
but these that I created are specifically for live use at stage volume
with an FRFR. They were created...
Glad you got it working!
You can assign a specific preset to a specific foot switch.
You can actually assign an A and B preset to one foot switch and
toggle between them....
Read this doc. It will explain everything:
Foot switch assignments
What you're hearing is the modeled sound of the power amp crossover distortion.
It's quite prevalent in the Bassman, Plexi and Rumble models....
Either is fine.
Just make sure the 1/4" input is set to line level if you use it.
Using a balanced cable is always preferred for noise issues....
Next step is a different power supply then.
Makes sure you don't daisy chain with other pedals.
Do you have 48V phantom power ON on the Ka6?
If so, turn it off.
I'm glad you're enjoying the AFB.
It's likely a ground loop noise.
If you disconnect the USB connection is the noise still there?
99% of problems...
In your DAW you want the meter to read about -10 to -5 dBFS.
But you want to make sure that you're not clipping the input of your audio interface....
Most everyone that uses the AmpliFire in a live setting goes direct to the FOH mixer.
But not everyone likes using a monitor mix or FRFR on stage...
Audio interfaces that have LINE LEVEL inputs often have either dedicated -10dB and +4dB inputs
or a switch that allows you to select between the...
The first thing to do is to make a backup file to save all your presets and settings if you don't have one already.
To to this use the editor and...
I understand and you are correct.
Perhaps in a future update we can address that.
It will work fine that way.
AmpliFire has a mono send, but a stereo return.
So your reverbs would still be in stereo in the FX loop.
I think these are great!
You can bypass the CAB IR for the signal going to your guitar amp
while the CAB IR is active for the signal going to FOH.
Personally I think it...
Personally I like the Cab IR ON even when going in to a real cab.
But to get a similar high frequency cut as the CAB block, set one of the PEQ...
Separate names with a comma.