Bank +10 not working

Discussion in 'Support & Bug Reporting' started by ChrisW, Apr 14, 2019 at 6:30 PM.

  1. ChrisW

    ChrisW New Member

    Joined:
    Feb 4, 2019
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Hello,

    I'm seeing some strange behavior trying to assign the Bank +10 function to something other than the arrow up button. I'm actually trying to assign it to the arrow down button but I observe the following behavior: when I press it once it acts like it's set to Bank -10. It only behaves correctly when I press and hold and then it increments the banks up by 10 rapidly. Other buttons I've tried to assign it to appear to exhibit the same problem. I have the latest FW installed on my Amplifire 12.

    --Chris
     
  2. Jace Nuzback

    Jace Nuzback Senior Member

    Joined:
    Apr 9, 2017
    Messages:
    843
    Likes Received:
    586
    Trophy Points:
    93
    Occupation:
    Product Specialist Atomic Amps
    Home Page:
  3. ChrisW

    ChrisW New Member

    Joined:
    Feb 4, 2019
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Thanks Jace. That's a bit non-intuitive but good to know it's acting as expected.

    --Chris
     

Share This Page

Share