FX presets

Here are some FX presets made using the US CLEAN amp model.
I made separate presets for 2 voice, 3 voice and 4 voice chorus.
They have some different parameter values besides just the different voice selection.

Once you have these presets loaded in to your unit you can copy the effects blocks
in to your own presets. For example the US CLEAN Phase Dly preset.
This one uses the PHASER and ECHO blocks.
Select this preset go to the PHASER block then select FILE-COPY CURRENT BLOCK PARAMETERS.
Then select one of your own presets and select FILE-PASTE PARAMETERS.
Click SAVE.
Select the US CLEAN Phase Dly preset again.
Select the ECHO block then select FILE-COPY CURRENT BLOCK PARAMETERS.
Then select one of your own preset again and select FILE-PASTE PARAMETERS.
Click SAVE again.
Now those PHASER and ECHO settings are in your preset.
You can change them to PRE or POST amp and experiment.
Have fun!
Jace

 

Thanks >>>
WISH LIST> ABILITY TO SAVE JUST PRESET BLOCKS

 

Agreed!

 

I just wanted to bump this so everyone knew it was there.

 

Sounds like foreshadowing, @Jace Nuzback!

When are we getting the new amps? And other surprises?

 

You think these could work well if I replaced US Clean with the 65 Clean?

 

Absolutely! They were actually created with the 65 Clean, but as the amp model wasn't released yet
I had to change the to the US Clean!

 

Thanks bro!!!

 

Thanks! Been struggling a bit finding a solid Chorus!