MIDI commands to change which parameter is controlled by expression 1 and 2

Discussion in 'Wishlist' started by Quadfire, May 21, 2020.

  1. Quadfire

    Quadfire Well-Known Member

    Joined:
    Apr 8, 2019
    Messages:
    145
    Likes Received:
    30
    Trophy Points:
    28
    Today we can control two parameters via MIDI CC that must be setup in advance. The assignment for expression 1 and expression 2 configure which parameter MIDI CC (and expression) can set a value for either of those.

    The AA needs a command to change which parameter is controlled by MIDI CC (for expression pedals 1 and 2).

    Details:
    • Ideally this change also holds the last value set for the old parameter unless otherwise changed.
    • This is probably two commands to handle all 140+ assignable params (since CC params are limited to 128 values).
    • OK to limit the rate at which this can be called (e.g., ignore multiple requests received faster than 100ms).
    This really unlocks a lot of value for the AA allowing many deep params to be changed on the fly (more than you could have presets) or varied continuously from a variety of other devices that simply need to send a midi message.
     

Share This Page

Share