Setting footswitch to do different things in different presets

Discussion in 'Discussion' started by Meiannatee, Dec 24, 2016.

  1. Meiannatee

    Meiannatee Well-Known Member

    Joined:
    Dec 20, 2016
    Messages:
    86
    Likes Received:
    40
    Trophy Points:
    18
    1) Is there a way to configure the footswitches to turn on/off different blocks for each preset?
    For example, in preset 1 - FS9 toggles Chorus on/off. In preset 2 - FS9 toggles Flanger on/off.

    2) In the editor, on the footswitches tab, I see a matrix with Amp, Boost, Echo,.... PEQ-3, and boxes for []Not assigned, []Assigned, []Invert.
    Currently they seem to do absolutely nothing.
     
  2. paulfrench

    paulfrench Well-Known Member

    Joined:
    Dec 21, 2016
    Messages:
    83
    Likes Received:
    33
    Trophy Points:
    18
    Location:
    Portland, Maine USA
    I know you can set the foot switch to "effects" and it will allow you to do this with modulation effects. I'm not sure how to set it for other effects, and it doesn't explain it in the manual. I think it can be done, but I haven't figured it out yet.
     
  3. bioboy

    bioboy Well-Known Member

    Joined:
    Dec 20, 2016
    Messages:
    122
    Likes Received:
    72
    Trophy Points:
    28
    Occupation:
    working dead...
    Location:
    3feet under...
    open the editor and click your desired preset
    once in click on the effect block you need to assign a footswitch and go down in the effect's parameters
    click on button menu and a pop-up with button list will showup than click on the desired footswitch to assign the effect
     
    Meiannatee likes this.
  4. RCL

    RCL Well-Known Member

    Joined:
    Dec 20, 2016
    Messages:
    52
    Likes Received:
    32
    Trophy Points:
    18
    Need to make sure per-preset is set up. If your global setting is set to anything else, the switch screen doesn't do much. Wish I could be more helpful but I am not near the unit today.
     
    Meiannatee likes this.
  5. Meiannatee

    Meiannatee Well-Known Member

    Joined:
    Dec 20, 2016
    Messages:
    86
    Likes Received:
    40
    Trophy Points:
    18
    How do I set to per-preset? Can I do it on the editor, or only on the unit itself?
     
  6. dbagchee

    dbagchee Well-Known Member

    Joined:
    Dec 20, 2016
    Messages:
    137
    Likes Received:
    124
    Trophy Points:
    43
    Location:
    Watsonville, CA
    Choose the Preset Assign footswitch option for the desired footswitch in the Footswitch tab of the editor. You can do this on the device as well but easier to see all the settings for a particular preset in the editor.
     
    Meiannatee likes this.
  7. Meiannatee

    Meiannatee Well-Known Member

    Joined:
    Dec 20, 2016
    Messages:
    86
    Likes Received:
    40
    Trophy Points:
    18
    Thank you so much! For some ready I thought that was to switch to a specified preset. Not sure how I missed it in the manual.
     
    dbagchee likes this.

Share This Page

Share