Preset assign (turn off Tuner?)

Discussion in 'Discussion' started by Douglas F, Jun 23, 2020.

  1. Douglas F

    Douglas F Member

    Joined:
    May 3, 2019
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    1
    Hey guys, I set preset "8" to change between the Chorus & Phaser. Can I assign the 3rd click to turn them off & instead of going to the tuner? Thanks for your help.

    upload_2020-6-23_12-50-27.png
     
  2. Jace Nuzback

    Jace Nuzback Senior Member

    Joined:
    Apr 9, 2017
    Messages:
    1,299
    Likes Received:
    890
    Trophy Points:
    113
    Occupation:
    Product Specialist Atomic Amps
    Home Page:
    No. Just pressing the switch will toggle between the chorus and phaser.
    Holding the foot switch down for a second will turn on the tuner.
    You can press ANY foot switch to turn the tuner off again.
     
  3. Quadfire

    Quadfire Well-Known Member

    Joined:
    Apr 8, 2019
    Messages:
    146
    Likes Received:
    30
    Trophy Points:
    28
    FYI, "footswitch down for a seconds" should work for any footswitch setup as Preset Assign or a single effect (e.g., Boost).

    I have noticed that the effect changes state (turns on) for a second before the tuner kicks in. Probably a good idea for the button actions to be tied to button release rather than button down. (Tap tempo would be a special case to keep on button down, but otherwise the timing impact is fine.). I consider this a small bug that affects live performance.
     

Share This Page

Share